This will allow your board to communicate with Mach3. Select the “USBMach V2.0” and check “Don’t ask me again”.
Step 4: Open Mach3 and you should be prompted to select a driver. It should automatically recognize the USB device. Step 3: Make sure your board is connected to the PC via USB cable. Step 2: Download the USB Motion Driver BL-UsbMach-V22.dll and copy and paste the file into your Mach3 Plugins folder Example: “C:/Users/ProgramFiles/Mach3/Plugins” Step 1: Install Mach3: If you already have a Mach3 Installed, skip this step. Windows 10 (Indirect using Windows XP on VMWare) Tested with the following Operating Systems: Power Status LED: 1 Status LED (indicate Power status of the controller board) Isolated Outputs: 4 general-purpose isolated relay drive output interface (can drive four relays for controlling the spindle starts, forward rotating and reverse rotating, pumps and other device) Spindle Control Output: Yes (0-10V output port) with Spindle Direction (FWD) output Optical Isolation between USB Side Control and External inputs: Yes Limit switches: Yes (5 general-purpose inputs, you can connect the limit switch, estop switch, probe switch, back to zero and other device) Maximum step-pulse frequency: 100KHz (suitable for smooth servo or stepper motion) No of Axis: 5 (you can connect 5 stepper motor drives or servo drives)
stepper motor drivers.Īll the port names are printed on board, Easy to be used It can be connected to stepper motor drivers using common anode or common cathode input connection.Note: stepper motor drivers should have photocouplers for input.Īlso, provide 5 axis XH2.54-4P 2.54mm Socket Connector ，make it is easy to connect to the stepper motor drivers. Mach3 USB interface board BL-UsbMACH-V20 manual PWM output is available ( ( photocoupler separated,5V) ，can be used to control the spindle speed controller that controlled by PWM.įour output ports are available， can be connected to relay modules with photocouplers, to control flood and mist, etc. Previously with LPT Port-Based Cards, the user was limited to use only older computers which had LPT Port.With this New CNC Control Board, you can even run Mach3 on a Windows Tablet which can give a more compact and professional look to your CNC Machine.
5-Axis 100KHz USB CNC Controller Card for Mach3 lets you use any Windows Computer to be used as CNC Machine Controller.
0 kommentar(er)
